NETGEAR ReadyNAS Duo v2
- Duo v1: admin/netgear1
- Duo v2: admin/password
Sources
Console extracts
With an arduino UNO (CONFIG_USB_ACM=y; group: uucp), command : picocom -b 115200 /dev/ttyACM0
__ __ _ _
| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__|
** MARVELL BOARD: DB-88F6282A-BP LE
U-Boot 1.1.4 (Jun 29 2012 - 16:06:40) Marvell version: 3.4.27
Netgear version: Uboot-1_1_4-NetgearDUOV3-V1009
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006D0120
Soc: MV88F1155 Rev 1 (DDR3)
CPU running @ 1600Mhz L2 running @ 533Mhz
SysClock = 533Mhz , TClock = 200Mhz
DRAM unknown CAL tRP = 8 tRAS = 20 tRCD=8
DRAM CS[0] base 0x00000000 size 256MB
DRAM Total size 256MB 16bit width
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:128 MB
Flash: 0 kB
CPU : Marvell Feroceon (Rev 1)
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: PCI Express Root Complex Interface
PEX interface detected Link X1
Plug On and Power down, Please Switch On !
NAND read: device 0 offset 0x200000, size 0x600000 Reading data from 0x7ff800 -- 100% complete. 6291456 bytes read: OK NAND read: device 0 offset 0x800000, size 0x1000000 Reading data from 0x17ff800 -- 100% complete. 16777216 bytes read: OK ## Booting image at 01200000 ... Image Name: Linux-2.6.31.8.duov2 Created: 2013-04-18 10:25:25 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 3442360 Bytes = 3.3 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK OK ## Loading Ramdisk Image at 02000000 ... Image Name: initrd Created: 2013-04-19 3:06:56 UTC Image Type: ARM Linux RAMDisk Image (gzip compressed) Data Size: 4382833 Bytes = 4.2 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK
~ # cat /proc/cpuinfo Processor : Feroceon 88FR131 rev 1 (v5l) BogoMIPS : 1599.07 Features : swp half thumb fastmult edsp CPU implementer : 0x56 CPU architecture: 5TE CPU variant : 0x2 CPU part : 0x131 CPU revision : 1 Hardware : Feroceon-KW Revision : 0000 Serial : 0000000000000000