logo

qmk_firmware

custom branch of QMK firmware git clone https://anongit.hacktivis.me/git/qmk_firmware.git

readme.md (1397B)

    

  1. # studiokestra/galatea
  3. ![studiokestra/galatea](https://i.imgur.com/juPhV1xh.png)
  5. TKL H87/88c compatible PCB with support for the most common layouts.
  7. * Keyboard Maintainer: [Studio Kestra](https://github.com/studiokestra/)
  8. * Hardware Supported: Most H87C compatible keyboards
  9. * Hardware Availability: https://RNDKBD.com; https://geon.works/
  10. * Rev1 firmware is used for Galatea PCBs with no RGB underglow.
  11. * Rev2 firmware is used for Galatea PCBs with RGB underglow.
  12. * Rev3 firmware is used for Galatea PCBs with RP2040 chip w/ RGB underglow.
  14. Make example for this keyboard (after setting up your build environment):
  16.     make studiokestra/galatea/rev1:default
  18. Flashing example for this keyboard:
  20.     make studiokestra/galatea/rev1:default:flash
  22. See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
  24. ## Bootloader
  26. Enter the bootloader in 3 ways:
  28. * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  29. * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
  30. * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available