qmk_firmware

readme.md (765B)

# Aurora Sweep's Debug Keymap
Due to the complex layer setup, the default keymap for the Aurora Sweep is relatively hard to debug.
This debug keymap should make that a lot easier.
## Keys
![Keys](https://raw.githubusercontent.com/splitkb/qmk_firmware/assets/aurora/sweep/keymaps/debug/keys.png)
The left side uses lowercase letters, the right side uses uppercase ones.
## Encoders
Encoders output a number of 0 to 3, depending on the installed position.
These correspond to the index used for custom encoder code.
The number is followed by either a `+` or a `-`, depending on the direction turned.
## LEDs
Both underglow and per-key RGB should be fading between red and off.
## OLEDs
Both the primary and secondary side should be filled with characters.