logo

qmk_firmware

custom branch of QMK firmware git clone https://anongit.hacktivis.me/git/qmk_firmware.git

readme.md (1355B)

    

  1. # Scotto34 (PCB Edition)
  3. ![Scotto34 (PCB Edition)](https://i.imgur.com/nTxYa7ih.jpg)
  5. A low profile 34-key split monoblock ortholinear keyboard that uses 18x17mm spaced Choc switches and an exposed controller in the middle.
  7. *   Keyboard Maintainer: [Joe Scotto](https://github.com/joe-scotto)
  8. *   Hardware Supported: Scotto34 (PCB Edition), Raspberry Pi Pico
  9. *   Hardware Availability: [ScottoKeebs](https://scottokeebs.com), [Amazon](https://amazon.com), [AliExpress](https://aliexpress.com)
  11. # Compiling
  13. Make example for this keyboard (after setting up your build environment):
  15.     make scottokeebs/scotto34:default
  17. Flashing example for this keyboard:
  19.     make scottokeebs/scotto34:default:flash
  21. See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
  23. # Bootloader
  25. Enter the bootloader in 3 ways:
  27. *   **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  28. *   **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
  29. *   **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available