logo

qmk_firmware

custom branch of QMK firmware git clone https://anongit.hacktivis.me/git/qmk_firmware.git

readme.md (2519B)

    

  1. # rp2040_orbweaver
  2. QMK firmware for RP2040 based MCU replacement PCB for the Razer Orbweaver gaming keypad
  4. ![RP2040 Orbweaver](https://i.imgur.com/GCPRUbs.png)
  7. This firmware is for the Razer Orbweaver Chroma keypad with a custom, plug and play, RP2040 MCU PCB. For installation instructions and board availability see [geekhack](https://geekhack.org/index.php?topic=124092.0).
  9. The firmware controls a 6x5 key matrix (4x5 keypad + 6 additional keys on the thumb pad and up to 4 additional keys added by user). It also controls a IS31FL3731 RGB Matrix controller (on the Chroma model) via I2C interface. This requires a single I2C Driver with 20 common anode RGB LEDs.
  11. Key 20 (bottom right) is used to switch layers.  
  13. The default key map provides 3 preset layers.  
  15. (layer 0) is a generic layer based on the original Razer defaults.  
  16. (layer 1) replaces modifier keys with letter keys.   
  17. (layer 2) replaces the 2 top rows with RGB control keys.  
  19. The three LEDs on the thumb pad indicate the active layer. 
  21. Blue = layer 0  
  22. Green = layer 1  
  23. Yellow = layer 3  
  25. All LEDs will be off when any other (user added) layout is activated
  27. A set of RGB animations are included in confg.h.  These are controlled by activating the Yellow layer and using keys 01 - 11 (11 toggles the lighting on and off - see /keymaps/default/keymap.c for more information)
  29. Many thanks to a_marmot. Without his original handwired project, this board would not have been possible. His original work can be found here. [geekhack](https://geekhack.org/index.php?topic=119396.0).
  31. * Keyboard Maintainer: [Lostdotfish](https://github.com/Lostdotfish)
  32. * Hardware Supported: RP2040 + IS31FL3731
  33. * Hardware Availability: [https://geekhack.org/index.php?topic=124092.0](https://geekhack.org/index.php?topic=124092.0)
  35. Make example for this keyboard (after setting up your build environment):
  37.     make lostdotfish/rp2040_orbweaver:default
  39. Flashing example for this keyboard:
  41.     make lostdotfish/rp2040_orbweaver:default:flash
  42.     
  44. See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
  46. ## Bootloader
  48. Enter the bootloader in 2 ways:
  50. * Press and hold the upper left hand key on the main keyboard while you plug in the USB.
  51. * Press and release the boot button on the top of the RP2040_Orbweaver v2.0 inside the modded unit.