logo

qmk_firmware

custom branch of QMK firmware git clone https://anongit.hacktivis.me/git/qmk_firmware.git

readme.md (1362B)

    

  1. # snatchpad
  3. ![snatchpad etch-a-sketch macropad](https://i.imgur.com/aRIM8Nah.jpg)
  5. A 6-key macropad with 2 rotary encoders intended for use as a pointing device.
  7. In addition to the 3d printed parts and microcontroller, the following hardware is required:
  8. * 4 * 3x3 mm threaded inserts
  9. * 4 * 4mm M3 bolt
  10. * USB daughter board
  12. ---
  14. * Keyboard Maintainer: [xia0](https://github.com/xia0)
  15. * Hardware Supported: e.g. Arduino Pro Micro
  16. * Hardware Availability: [github](https://github.com/xia0/keeb_files/tree/main/snatchpad)
  18. Make example for this keyboard (after setting up your build environment):
  20.     make handwired/snatchpad:default
  22. Flashing example for this keyboard:
  24.     make handwired/snatchpad:default:flash
  26. See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
  28. ## Bootloader
  30. Enter the bootloader in 3 ways:
  32. * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  33. * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
  34. * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available