logo

qmk_firmware

custom branch of QMK firmware git clone https://anongit.hacktivis.me/git/qmk_firmware.git

readme.md (1498B)

    

  1. # dactyl_manuform_pi_pico
  3. ![dactyl_manuform_pi_pico](https://i.imgur.com/T9b74bI.jpg)
  5. This is a dactyl_manuform 5x6 running Rasrberry Pi Pico.
  6. It's based on alcor_dactyl but with more reasonable GPIO layout for Pi Pico
  7. and clasic dactyl_manuform layout (pinkies have only 4 rows).
  9. Build instructions: https://github.com/GustawXYZ/dactyl_manuform_pi_pico/ 
  11. * Keyboard Maintainer: [Gustaw.xyz](https://github.com/Gustaw.xyz)
  12. * Hardware Supported: Raspberry Pi Pico and other RP2040
  13. * Hardware Availability: https://www.raspberrypi.com/products/raspberry-pi-pico/
  14. * 3D Print model: https://github.com/abstracthat/dactyl-manuform
  16. Make example for this keyboard (after setting up your build environment):
  18.     make handwired/dactyl_manuform_pi_pico:default
  20. Flashing example for this keyboard:
  22.     make handwired/dactyl_manuform_pi_pico:default:flash
  24. See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
  26. ## Bootloader
  28. Enter the bootloader in 3 ways:
  30. * **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  31. * **Physical reset button**: Briefly press the button on the back of the PCB - some may have pads you must short instead
  32. * **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available