logo

qmk_firmware

custom branch of QMK firmware git clone https://anongit.hacktivis.me/git/qmk_firmware.git

readme.md (1913B)

    

  1. # GMMK PRO (ANSI)
  3. A tenkeyless 75% keyboard made and sold by Glorious LLC. Equipped with the STM32 ARM Cortex-M4 microcontroller, with support for rotary encoders and three additional layouts. [More info at Glorious](https://www.pcgamingrace.com/products/glorious-gmmk-pro-75-barebone-black-reservation)
  5. * Keyboard Maintainer: [GloriousThrall](https://github.com/GloriousThrall)
  6. * Hardware Supported: GMMK Pro
  7. * Hardware Availability: [GloriousPCGaming.com](https://www.pcgamingrace.com/products/glorious-gmmk-pro-75-barebone-black-reservation)
  9. Make example for this keyboard (after setting up your build environment):
  11.     make gmmk/pro/rev1/ansi:default
  13. Flashing example for this keyboard:
  15.     make gmmk/pro/rev1/ansi:default:flash
  17. To reset the board into bootloader mode, do one of the following:
  19. * Hold the Reset switch mounted on the bottom side of the PCB while connecting the USB cable
  20. * Hold the Escape key while connecting the USB cable (also erases persistent settings)
  21. * Fn+Backslash will reset the board to bootloader mode if you have flashed the default QMK keymap
  23. See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
  25. ## Case Screw Replacements
  27. Many users report stripped case screws when disassembling the board.
  29. The stock case screws are:
  30. * Thread: M2
  31. * Thread length: ~5 mm
  32. * Head diameter: ~3.8 mm
  33. * Head counterbore diameter: ~4.0 mm
  34. * Head counterbore depth: ~1.9 mm
  36. Most M2x5mm screws should fit fine, although it's best to ensure that the screw head will fit inside the counterbore.
  37. For reference, [this hex socket head screw](https://www.mcmaster.com/91292A005/) from McMaster-Carr should fit nearly flush (head will protrude above the counterbore by ~0.1 mm).